Measurement-computing DIAdem Manuale Utente Scaricare il pdf (Pagina 6)

4 DIA

dem



Quick Start Guide

09-06-00

DIA

dem



Select Options and Click <Finish>.

Just before the setup is complete, you will see the following two option check boxes.

Display the latest information now

–

This box is checked by default. Leaving the boxed checked brings up the readme file

contents listed below. We recommend that you leave this box checked.

Start the program now

–

Launches the

DIA

dem program for immediate use.

After selecting one, both, or neither option, click <Finish> to complete the setup.

Readme File Contents

Readme file contents are subject to change. File categories are typically as follows:

Getting Started

Updates to the Current Version

Additional Information

Conditions for Use

Launching DIA

dem

from an Acquisition Program

The steps in this section do not apply to ChartView

The following steps can be used with data acquisition programs that contain a file converter capable

of converting raw binary data to the DIA

dem

data format. ChartView User’s should skip to the

following section, Using DIAdem with ChartView.

Reference Note:

The following steps apply to DaqView, Personal DaqView, LogView, and WaveView. The steps

are discussed in general terms since the data acquisition programs differ in regard to toolbars, pull-

down menus, and other aspects of GUI layout. Refer to your specific application’s documentation

as needed.

1. Include the DIA

dem

File Format as a Data Conversion Preference

Verify DIA

dem

is selected as a file format. This is

accomplished through your application’s

“Conversion Preferences.”

Refer to your application’s user documentation as

needed.

Note: DIA

dem

is initially selected by default.

Selecting DIAdem as a File Format

2. Acquire Data to Disk and Convert File

When acquiring data to disk, your application’s file

converter automatically converts the Raw Binary data

to the DIA

dem

Target Format (verified in the

previous step).

During the conversion, a “Converting File” box

shows: an animated completion bar, format of the

source and target files, and file paths of the source

and target. The box is usually on screen for only a

moment; however, we can obtain the information

from your application’s Data Destination region,

as mentioned in the following tip.

File Conversion in Progress

1 2 3 4 5 6 7 8 9 10 11 ... 37 38

Commenti su questo manuale

Nessun commento

Measurement-computing DIAdem Manuale Utente Pagina 6

Commenti su questo manuale

Prodotti e manuali riguardandi Hardware Measurement-computing DIAdem