Measurement-computing PC104-PDISO8 Manuale Utente Scaricare il pdf (Pagina 6)

2 INSTALLATION

2.1 SOFTWARE

Before you open your computer and install the board, install and run

Insta

Cal, the

installation, calibration and test utility included with your board.

Insta

Cal will guide

you through switch and jumper settings for your board. Detailed information

regarding these settings can be found below. Refer to the

Extended Software

Installation Manual

for

Insta

Cal installation instructions.

2.2 BASE ADDRESS

The base address switch controls the I/O location where the CPU can access the

board’s registers.

The factory default is 300 hex (768 decimal).

If you already have a board installed at address 300h, choose a new address from

those available on your computer.

Use the list of PC I/O address

assignments found in Table 2-1 to

determine the appropriate address.

Choose a new base address from

those available and set the switch

using the guide to the right.

If 300 hex is available on your

computer, there is no need to

change this switch from the factory

default setting.

Figure 2-1. Base Address Switch

1 2 3 4 5 6 7 8 9 10 11 ... 19 20

Nessun commento

Measurement-computing PC104-PDISO8 Manuale Utente Pagina 6