457-0941, rev 1.2
03-01-00
DaqBook Quick Start Guide 3
4.
Connect the supplied AC-to-DC adapter’s jack-end to DaqBook’s
POWER IN
connector.
5.
Connect the adapter’s plug to a standard AC outlet.
6.
To verify connections, turn
ON
the power switch by rotating the rocker-arm switch to the “
1
” position. The
POWER LED
should
light up.
If connecting your DaqBook to a notebook PC
, you can use a
WBK20A, PCMCIA Interface Card. Refer to separate instructions
(supplied with the WBK20A) if applicable.
If connecting your DaqBook to a desktop PC (with no available
EPP port),
you can use a WBK21 Interface card. Refer to separate
instructions (supplied with the WBK21) if applicable.
Reference Note:
It is possible to use a different VDC power source (instead of the adapter); however, you should
consult the Power Management Section of your user’s manual before doing so.
(4) Install Software
1.
Remove previous version Daq* software, if present. You can do
this through Microsoft’s Add/Remove Programs feature by
navigating from your desktop as follows:
Start ⇒ Settings ⇒ Control Panel ⇒ Add/Remove Programs
2.
Place the Data Acquisition Software CD in the host PC’s
CD-ROM drive.
Wait for PC to auto-access the CD. This
may take a few moments, depending on your PC.
3.
If a Licensing Agreement appears, read over the agreement,
then click “Agree.” The Data Acquisition Software Master
Setup Screen appears (see figure at right).
4.
Select
DaqBook/DaqBoard Support.
For Windows95/98/NT
(or more recent Windows), select
32-bit
.
If using Windows3.1, or DOS,
select
16-bit
instead of 32-bit.
5.
If you do not have Acrobat Reader version 3.0 or greater
installed on your PC, select
Acrobat Reader
. This will
enable you to read and print documentation that is included
on the install CD-ROM.
6.
Select
DIAdem Post Acquisition Data Analysis
Program
. Refer to your separate DIAdem document
(p/n 457-0903) for information regarding DIAdem.
7.
Click “
Start Install
.”
8.
Follow screen prompts.
(5) Test Hardware
1.
Run the
Daq Configuration
control panel applet.
2.
Click “
Add Device
.”
3.
Select your DaqBook model from the “
Device Type
” scroll box and click
OK
.
4.
Select your DaqBook from the “
Device Inventory
” window and click “
Properties
.”
5.
Ensure settings are correct, and make changes if needed.
6.
Select the
Test Hardware
tab.
7.
Verify DaqBook has been properly installed and powered-on. Make sure the parallel port cable
is firmly in place on both the DaqBook and the host PC’s LPT port.
Device Type Window
(5 pagine)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commenti su questo manuale