Measurement-computing Extender488 Manuale Utente Scaricare il pdf (Pagina 13)

Section 2 Getting Started

WARNING

Never open the Extender488 case while it is connected to th e AC line.

Failure to obs erve this warning may result in equipment failure, personal

injury or death.

Remove the four screws located in each corner of the rear panel. Hold the case firmly and

pull the rear panel outward, noting the slot location of the main circuit board. Modify those

parameters which are appropriate for your installation and reassemble the unit. Slide the main

circuit board into the previously noted slot and finish reassembly by tightening the four screws into

the rear panel.

Extender488 Baud Rate Selection

DOT

Switch

Side

View

OPEN

1234

S102

123

000

100

001

300

600

1200

2400

4800

9600

19200

115200

Baud Rate

Default = 115200

2.2.2 Extender488 Serial Data Format Selection

The

Extender488

is configurable for two data formats. The first, factory default, format is 8

data bits, 1 stop bit with odd parity. The number of data bits transmitted can be set to 7 by setting

S102 switch

4 to the closed position. Even though the seven bit format is chosen, binary data can

still be transferred over the

Extender488

's. There will, however, be a slight degradation in data

transfer speeds with this format.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 38 39

Commenti su questo manuale

Nessun commento

Measurement-computing Extender488 Manuale Utente Pagina 13

Commenti su questo manuale

Prodotti e manuali riguardandi Hardware Measurement-computing Extender488