Measurement-computing PC104-DAS16JR/12 Manuale Utente Scaricare il pdf (Pagina 5)

1 INSTALLATION

1.1 SOFTWARE

Before you open your computer and install the board, install and run InstaCal™, the

installation, calibration and test utility included with your board. InstaCal™ will guide

you through switch and jumper settings for your board. Detailed information

regarding these settings can be found below. Refer to the Software Installation manual

for InstaCal™ installation instructions.

1.2 HARDWARE

The PC104-DAS16Jr/12 has one bank of switches, two single function switches and

one jumper block which must be set before installation of the board inside your

computer (Figure 1-1). The PC104-DAS16Jr/16 has one additional switch for

selecting unipolar or bipolar ranges (Figure 1-2).

Figure 1-1. PC104-DAS16Jr/12 Switch & Jumper Locations

ADDRESS

DIP SWITCHES

300h Default

DMA LEVEL

SELECT SWITCH

CRYSTAL OSC.

FREQ. SELECT

JUMPER

1 or 10 MHz

(1=UP)

8 or 16

HANNEL

ELE

SWITCH

PIN 1

(UNDER)

1 2 3 4 5 6 7 8 9 10 ... 31 32

Nessun commento

Measurement-computing PC104-DAS16JR/12 Manuale Utente Pagina 5