Measurement-computing PCI-DDA02/12 Manuale Utente Scaricare il pdf (Pagina 7)

PCI-DDA02/12 User's Guide Installing the PCI-DDA02/12

Complete the following steps to install the board:

1. Turn your computer off, open it up, and insert your board into an available PCI slot.

2. Close your computer and turn it on.

When you connect the device for the first time to a computer running Windows, a Found New Hardware

dialog opens when the operating system detects the device. If the information file for this board is not

already loaded onto your PC, you will be prompted for the disk containing this file. The MCC DAQ

software contains this file. If required, insert the Measurement Computing Data Acquisition Software CD

and click OK.

3. To test your installation and configure your board, run the InstaCal utility you installed in the previous

section. Refer to the Quick Start Guide that came with your board www.mccdaq.com/PDFmanuals/DAQ-

Software-Quick-Start.pdf for information on how to initially set up and load InstaCal.

Signal connections

The table below lists the board connectors, applicable cables and compatible accessory boards.

Connector type

100-pin, high density connector

Compatible cables

C100FF-x unshielded ribbon cable (x = length in feet)

Compatible accessory products with

the C100FF-x cable

SCB-50

CIO-TERM100

CIO-MINI50 (two required)

1 2 3 4 5 6 7 8 9 10 11 12 ... 17 18

Nessun commento

Measurement-computing PCI-DDA02/12 Manuale Utente Pagina 7