Measurement-computing 200 Series DaqBook Manuale Utente Scaricare il pdf (Pagina 36)

3-18 DaqBook Hardware

01-23-02

DaqBook User’s Manual

Using T-Cables

&$87,21

Turn power OFF to the Daq devices and externally connected equipment while

connecting cables and setting configuration jumpers and switches or before opening

the lid. Electrical shock or damage to equipment can result even under low-voltage

conditions.

T-Cables are available in different lengths and can be used for linking two or more compatible devices

together via the device’s 37-pin digital I/O connectors.

The bottom-end of the T-Cable is a dual-connector, consisting of both a female connector, and a 37-pin

(male) connector. As seen in the following illustration, the T-Cable’s 37-pin (male) connector can be used

for “Daisy-Chain” applications.

Each T-Cable comes with three sets of screws. These are designated (in the diagram) as: short, medium, and

long. Use the short screws to secure the single, female-end of the cable to the device; and use the medium

length screws to secure a cable’s “dual-end” connector. Use the long screws for daisy-chain applications

(when you are connecting one T-Cable to another T-Cable).

Tighten screws snug only; do not over-tighten!

Daisy-Chain Example, Using Two T-Cables

Daisy-Chain Example, Using two T-Cables

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 53 54

Nessun commento

Measurement-computing 200 Series DaqBook Manuale Utente Pagina 36