Measurement-computing USB-ERB08 Manuale Utente Scaricare il pdf (Pagina 12)

USB-ERB08 User's Guide Installing the USB-ERB08

Relay control logic parity

Configure the

Invert/non-invert switch (S1) to set the relay control logic polarity for each relay bank for invert

or non-invert. By default, this switch is shipped with all banks configured for non-inverted logic, as shown in

. Figure 2-3

Figure 2-3. Invert/non-invert switch (S1)

NON-INVERTINVERT

PULL UPPULL DOWN

 NON-INVERT mode: when "0" is written or read back via the USB bus, the relays are not energized.

 INVERT mode: when "0" is written or read back via the USB bus, the relays are energized.

Switch settings for polarity can be read back via software through the USB bus. Switch settings for S1 do not

affect the power-on condition.

Relay power-on state

Configure the

Pull-up/pull-down switch (S2) to set the state of each relay bank at power-up. By default, this

product is shipped with the switch for all banks configured for pull-down (relays inactive at power up), as

shown in . Figure 2-4

Figure 2-4. Pull-up/pull-down switch (S2)

When set to pull-up, the relays are put into an energized state at power-up, regardless of the state of switch S1.

When set to pull-down, the relays are put into a non-energized state at power-up.

Switch settings can be read back via software through the USB bus.

Connecting the external power supply

Power to the USB-ERB08 is provided with the 9 V, 1 A external power supply (CB-PWR-9). You must connect

the external power supply before connecting the USB connector to the USB-ERB08.

To connect the power supply to your USB-ERB08, do the following:

Connect the external power cord to the power connector labeled

POWER IN on the USB-ERB08 enclosure

(PWR IN on the board). Refer to Fi for the location of this connector. gure 3-1

Plug the AC adapter into a power outlet.

The

PWR LED illuminates green when 9 V power is supplied to the USB-ERB08. If the voltage supply is less

than 6.0 V or more than 12.5 V, the PWR LED does not light.

2-3

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 22 23

Nessun commento

Measurement-computing USB-ERB08 Manuale Utente Pagina 12